Underground Mining Methods
Under certain circumstances surface mining can become prohibitively expensive and underground mining may be considered. A major factor in the decision to operate by underground mining rather than surface mining is the strip ratio, or the number of units of waste material in a surface mine that must be removed in order to extract one unit of ore. Once this ratio becomes large, surface mining is no longer attractive. The objective of underground mining is to extract the ore below the surface of the earth safely, economically, and with as little waste as possible. The entry from the surface to an underground mine may be through an adit, or horizontal tunnel, a shaft (see shaft sinking), or vertical tunnel, or a declined shaft. A typical underground mine has a number of roughly horizontal levels at various depths below the surface, and these spread out from the access to the surface. Ore is mined in stopes, or rooms. Material left in place to support the ceiling is called a pillar and can sometimes be recovered afterward. A vertical internal connection between two levels of a mine is called a winze if it was made by driving downward and a raise if it was made by driving upward.
A modern underground mine is a highly mechanized operation requiring little work with pick and shovel. Rubber-tired vehicles, rail haulage, and multiple drill units are commonplace. In order to protect miners and their equipment much attention is paid to mine safety. Mine ventilation provides fresh air underground and at the same time removes noxious gases as well as dangerous dusts that might cause lung disease, e.g., silicosis. Roof support is accomplished with timber, concrete, or steel supports or, most commonly, with roof bolts, which are long steel rods used to bind the exposed roof surface to the rock behind it.
Sections in this article:
The Columbia Electronic Encyclopedia, 6th ed. Copyright © 2012, Columbia University Press. All rights reserved.
More on mining Underground Mining Methods from Infoplease:
See more Encyclopedia articles on: Metallurgy and Mining: Terms and Concepts